Descargar Imprimir esta página

Mopedia RP751 Manual De Instrucciones página 19

Publicidad

Idiomas disponibles

Idiomas disponibles

9.5 Seat
Before sitting, place the rollator on a flat and solid surface and then lock the brakes. Make sure
the brakes are securely locked and that the rollator is in a stable position.
WARNING! Sit down distributing your weight on the seat. Do not sit by pushing
only on one side.
10. HOW TO USE
• Start pushing when you are in an upright position with both hands on the handle;
• Make sure your hands are dry before using the rollator to avoid the risk of slipping;
• Walking maintaining an upright position with his eyes facing forward and not down;
• Do not push the rollator too far away from the body, this may cause falls and loads inadequate;
• Do not use the rollator to overcome steps higher than 20mm;
• When using outdoors, prefer the sidewalks properly prepared in accordance regulations for the
removal of architectural barriers.
11. CARE AND MAINTANANCE
The devices MOPEDIA by Moretti SpA on the market are carefully checked and carry the CE mark.
For the safety of the patient and the doctor is recommended to be checked by the manufacturer
or by an approved laboratory, at least every 2 years, the suitability for use of your rollator. If
repairs are to be used only original spare parts and accessories. The useful life of the product
depends on the use, maintenance, storage and cleaning.
12. CLEANING AND DISINFECTION
12.1 Cleaning
To clean the product, use only a wet cloth and dry it with a clean and dry cloth, or with warm water
and neutral soap. The manufacture company cannot be held responsible for the damage that is
caused by using materials that could damage the product surface or corrosive chemicals during
cleaning.
12.2 Disinfection
If you need to disinfect the product use a common disinfectant neutral detergent.
WARNING! Do not use abrasive substances, acids, alcohols, detergents based
on chlorine, disinfections and acetone, becouse the se substances cause
abrasion of the plastic parts and bustingof metal surfaces.
13. WHEEL CARE
1. Clean the wheels with warm water and mild detergent. Wipe dry with a clean cloth.
2. Periodically lubricate the wheels.
14. CONDITIONS OF DISPOSAL
When disposing of the device never use the normal return systems of municipal solid waste.
It is recommended instead to disposal through the joint municipal ecological islands for the
expected operations of recycling the materials used.
7

Publicidad

loading