Connections And Control Devices - ESAB Warrior Feed 304 Manual De Instrucciones

GB
WARNING
To prevent the reel from sliding off the hub: Lock the
reel in place by turning the red knob as shown on the
warning label attached next to the hub.
Before threading welding wire, make sure the chisel point and burrs have been
removed from the end of the wire to prevent the wire from jamming in the torch
liner.
WARNING
Rotating parts can cause injury, take great care.
WARNING
There is a risk of tipping if the wire feed unit is fitted with a counterbalance arm.
Secure the equipment, especially if used on an uneven or sloping surface.
5.1

Connections and control devices

1 Display voltage (V)
2 Display current (A)
3 Knob for setting the wire feed speed
4 Knob for setting the voltage
5 Switch for wire inching or gas purge
6 Connection RED for cooling water from
)
welding torch *
7 Connection BLUE for cooling water to the
)
welding torch *
8 Connection for the welding gun
)
* NOTE! Cooling water connections only available on certain models.
bm55d1e
9 Switch for creep start (inside)
10 Switch for 2-stroke / 4-stroke (inside)
11 Connection for welding current from power
source (OKC)
12 Connection for control cable from power
source
13 Connection for shielding gas
14 Connection BLUE for cooling water from
power source (cooling unit) *
15 Connection RED for cooling water to
power source (cooling unit) *
- 38 -
)
)
© ESAB AB 2013