Mounting The Cutting Attachment - Stihl FS 40 Manual De Instrucciones

Mounting the Cutting
Attachment
Preparations
Lay your trimmer on sits back with
N
the loop handle and shroud pointing
down and the output shaft facing up.
Thrust Plate
The thrust plate is shipped with the
PolyCut 6-3 and FixCut 5-2. It is only
required for these mowing heads.
FS 40, FS 40 C, FS 50, FS 50 C
1
3
2
4
STIHL AutoCut 5-2 mowing head,
STIHL AutoCut C 5-2 mowing head
Pull the thrust plate (1), if fitted, off
N
the shaft.
STIHL PolyCut 6-3 mowing head,
STIHL FixCut 5-2 mowing head
Slip the thrust plate (1) over the
N
shaft (2) and engage hex recess (3)
on the external hexagon (4).
Mounting the Mowing Head
Keep the instruction sheet for the
mowing head in a safe place.
STIHL AutoCut 5-2
4
2
1
3
Fit the spring (1) in the mowing
N
head (2).
Wind the mowing line (3) on to the
N
spool (4).
Thread the nylon line through the
N
sleeves and fit the spool in the head.
The individual steps are described in the
instruction sheet supplied.
English
3
17