Stihl FS 40 Manual De Instrucciones página 34

English
Hold the mowing head steady.
N
Rotate the spool counterclockwise
N
until the shortest line is about 4 in
(10 cm).
If necessary, cut the longer line to a
N
length of about 4 in (10 cm).
The mowing head is now full.
STIHL AutoCut 5-2
Always check the mowing head for signs
of wear before replacing the nylon line.
If there are signs of serious wear,
replace the parts concerned or install a
new mowing head.
32
Preparations
Shut off the engine.
N
Put the machine on the ground with
N
the mowing head facing up.
Removing remaining nylon line
1
2
Open the mowing head – hold it
N
steady with one hand.
Turn the cap (1) counterclockwise.
N
Disengage the spool (2), take it out
N
of the mowing head and remove the
remaining line.
Winding line onto spool
A prewound spool (special accessory)
may be used as an alternative to the
following procedure.
3
4
3
Use green-coded nylon line with a
N
diameter of 0.08 in (2.0 mm).
Cut two 10ft (3 m) lengths of nylon
N
line from the reel (special
accessory).
Insert the ends of each line (3) in the
N
holes (4) in the spool.
Bend the ends of the lines over the
N
edge of the holes to form a hook.
FS 40, FS 40 C, FS 50, FS 50 C