Omron MicroAir NE-U100 For Manual De Instrucciones página 5

Idiomas disponibles

Important Safety Information

• Allow the parts to dry after cleaning before reassembling and store in a clean location so that this

device will not become contaminated.

• DO NOT immerse the main unit (except the vibrating element and the area around the vibrating

element) and the AC adapter in water or other liquid.

• DO NOT spill water or medication on the main unit and the AC adapter.

• DO NOT leave the cleaning solution in the parts. Rinse the parts with clean tap water after

cleaning.

• Store this device and the components in a clean, safe location.

AC Adapter (optional accessory) Handling and Usage

• DO NOT use the AC adapter if this device or the AC adapter cable is damaged. If this device or the

cable is damaged, turn off the power and unplug the AC adapter immediately.

• Plug the AC adapter into the appropriate voltage outlet. DO NOT use in a multi-outlet plug.

• NEVER plug in or unplug the AC adapter from the electric outlet with wet hands.

• DO NOT disassemble or attempt to repair the AC adapter.

Indicates a potentially hazardous situation which, if not avoided, may result

Caution:

in minor or moderate injury to the user or patient, or cause damage to the

equipment or other property.

• This device is intended for human use only.

• To avoid the medication residue on the face, be sure to wipe the face after removing the mask.

• DO NOT get nebulized medication in your eyes.

• DO NOT operate this device if the medication container is empty.

• Use ONLY Omron authorized parts and accessories (Refer to section 6). Parts and accessories not

approved for use with this device may damage the unit.

• DO NOT add more than 10ml of medication to the medication container.

• DO NOT subject the device to any strong shocks such as dropping the device on the floor.

• DO NOT cover the main unit with items such as a blanket or towel during use.

• DO NOT disassemble or attempt to repair the main unit or AC adapter.

• DO NOT push or poke at the mesh with items such as a cotton swab or pin.