Sabo 92-13 H B Manual Del Operador página 67

HOW TO USE THE MACHINE
5.4.12 Card protection device
The electronic circuit board has a self-resetting protector which breaks the circuit if
there is a fault in the electrical system. This causes the engine to shutdown and is indi-
cated by complete shutdown of the control panel.
The circuit automatically resets after a few seconds but the cause of the fault should
be ascertained and dealt with to avoid reactivating the protection device.
IMPORTANT
– do not invert the leads on the battery terminals;
– do not use the machine without its battery or damage may be caused to the
charging regulator;
– be careful not to cause short-circuits.
5.4.13 Summary of main steps to follow when using the machine
To ...
Start the engine (
Go forward ( 5.4.2)
Brake or stop ( 5.4.3)
Reverse ( 5.4.4)
Cut the grass ( 5.4.5)
Empty the grass-catcher (
Unblock the collector channel (
Finish mowing ( 5.4.8)
Stop the engine ( 5.4.9)
Store the machine (
To avoid activating the protection device:
5.4.1)
5.4.6)
5.4.7)
5.4.10)
You will need to ...
Open the fuel stopcock, ensure that all the conditions
allowing starting are met, and then turn the key.
Apply the throttle;
press the drive pedal forwards (
Reduce the engine speed and press the brake pedal.
Stop the machine;
press the drive pedal backwards (
Fit the grass-catcher or stone-guard and apply the throttle;
engage the blades and adjust the cutting height.
press the drive pedal forwards (
Stop moving forwards, disengage the blades and pull out
the lever to tip up the grass-catcher.
Stop moving forwards, disengage the blades and turn off
the engine. Remove the grass-catcher and clean the col-
lector channel.
Disengage the blades and reduce the engine speed.
Reduce the engine speed, wait a few seconds, turn the key
and close the fuel stopcock.
Engage the parking brake, remove the key and, if neces-
sary, wash the machine, the inside of the cutting deck, the
collector channel and the grass-catcher.
EN
4.32);
4.32).
4.32);
25