Weber S-460 Manual De Instrucciones página 10

Ocultar thumbs Ver también para S-460:

Idiomas disponibles

Some LP tanks have differing top collar assemblies . (The top collar is the metal protective

ring around the valve .) One series of tanks mount with the valve facing front (1) . The other

tanks mount with the valve facing away from the fuel scale (2) . Weber recommends

Manchester or Worthington tanks with a 47 .6 lb water capacity . Other tanks may be

acceptable for use with the appliance provided they are compatible with the appliance

retention means (see illustrations) .

The LP tank is installed inside the tank enclosure, on the tank scale (left side) .

A) Loosen tank lock wing nut . Swing tank lock up (3) .

B) Turn the LP tank so the opening of the valve is either to the front or side of the

Weber

gas grill .

C) Lift tank up into position on the tank scale (4) .

D) Swing the tank lock down . Tighten the wing nut .

Connect The Hose To The Tank

A) Remove the plastic dust cover from the valve .

B) Screw the regulator coupling onto the tank valve, clockwise, or to the right . Hand-

tighten only (5) .

Note: This connection tightens clockwise and will not allow gas to flow unless the

connection is tight. The connection requires tightening by hand only.

m WARNING: Do not use a wrench to tighten the connection.

Using a wrench could damage the regulator coupling and

could cause a leak.

◆

GAS INSTRUCTIONS