Descargar Imprimir esta página

Xylem SI Analytics CT 72/P Manual De Instrucciones página 58

Termostatos transparentes

Publicidad

Idiomas disponibles

Idiomas disponibles

Burn hazard
Some parts of the device may become extremely hot during continuous
operation.
Always protect yourself against accidental contact.
Notice:
Before initial operation
These operating instructions must be carefully studied! It contains important
information on the connection to the local mains supply, correct unit usage and safe
handling.
Check for tranportation damage during unpacking.
Do not try to start up a damaged unit before the damage has been repaired or you
have ascertained the effect of the damage. Get in contact with supplier and/or carrier
for settlement of damage claims
Repairs, alterations or modifications must only be carried out by specialist personnel
Considerable damage can be caused by improper repairs. The SI Analytics GmbH
service department is at your disposal for repair work.
Never remove warning labels!
Initial operation
Only connect the unit to a power socket with an earthing contact (PE – protective
earth). Electrical connections and any other work must be performed by qualified
personnel only. The power supply plug serves as a safe disconnecting device from
the line and must always be easily accessible. Never operate units with damaged
mains power cables.
Place the unit on an even surface on a base made of nonflammable material.
Set the excess temperature safety installation at least 25 °C below the fire point of the
bath fluid.
Operation
Only use this unit solely for the intended application.
Never operate the unit without bath fluid in the bath! Only use the heat transfer liquids
recommended by SI Analytics GmbH
Do not operate the unit with wet or oily hands.
Do not expose the unit to spray water or immerse it in water.
Do not drain the bath fluid while it is hot.
Cleaning
Do not clean the unit with solvents (fire risk!) – a wet cloth soaked in household
detergent is normally sufficient.
Transportation
Do not move the instrument while it is running or hot. Always empty the bath before
moving the unit. Transport the unit with care. Sudden jolts or drops may cause
damage in the interior of the unit.
Safety notes
58

Publicidad

loading