Publicidad
Idiomas disponibles
Idiomas disponibles
After you have stepped down from the scale it
sounds "This appliance is ready for use" and you
can then start another measurement.
If you simply wait, the scale will indicate by a dou-
ble beep that it has switched itself off.
Warning indicators
Should your weight exceed the maximum weighing
capacity of 150 kg / 300 lb, "0 - Ld" is shown in the
display 2. You should IMMEDIATELY step down
from the scale, otherwise it could be damaged.
If the display 2 shows "L0" and "battery weak"
sounds, you must replace the batteries.
If the display 2 shows "Err" and "Error" sounds, the
scale cannot measure. In this case, step down from
the scale, wait a few seconds and then try again.
Take note that you need to both stand still and not
interrupt the weighing procedure.
Replacing the batteries
1. Open the battery compartment 1 and remove
the batteries.
2. Insert 3 new batteries of the type Micro/AAA/
LR03 as per the polarities specified in the bat-
tery compartment 1.
3. Close the battery compartment 1. The battery
compartment lid must click in audibly.
Usage and safe-keeping
• Avoid unnecessary battery discharge.
Accordingly, do not place objects on the glass
scale when it is not being used.
Remove the batteries if you do not intend to use
the scale for an extended period.
• Keep the scale at a clean and dry location.
• Avoid electrostatic charging.
• Your scale is a sensitive electronic device. As such,
it can occasionally be disturbed by other high-
frequency appliances that are being operated in
the immediate vicinity (e.g. mobile telephones,
CB radio stations, radio remote controls and
microwave ovens).
Should irregular or inaccurate errors be indicated
in the display 2, either remove the scale from the
source of the disturbance or switch the source of the
disturbance off whilst you are using the appliance.
Cleaning
Clean your scale exclusively with a neutral detergent
and a soft cloth.
- 30 -
Publicidad
