Publicidad
Idiomas disponibles
Idiomas disponibles
ATTENTION Read before start-up
This appliance can be used by children aged 8 years and older and people with
reduced physical, sensory or mental capabilities or lack of experience and
knowledge if they have been given appropriate supervision or training in the use
of the appliance in a safe way and understand the dangers involved. Children
should not play with the appliance. Children without supervision should not do
the cleaning and maintenance to be carried out by the user.
Recommended operating and rest times:
- Manual models: 3 minutes working, 15 minutes stop.
- Electronic models : 6 seconds working, 44 seconds stop.
Cleaning instructions for parts in contact with food:
All cleaning must be done with the grinder unplug using On/OFF switch (11).
For the hopper's cleaning, you should remove the Hopper of coffee beans (2), wash
it using a highly diluted solution of dishwasher liquid in water (by hand). Make
sure the hopper is completely dry before re-attaching it.
For the blades' cleaning, remove the coffee beans Hopper (2), remove the platen
by pressing the adjustment pawl (6). Cleaning using a dry brush. Replace all the
parts.
For the dispenser's cleaning, empty the dispenser (8), remove the dispenser lid (7).
Cleaning the dispenser with a dry brush. Replace the parts.
For the outer body of the coffee grinder cleaning, use a soft cloth dampened in
water.
How to properly use protections against moving parts:
There is a safety guard located in the lower portion of the coffee bean Hopper (2)
to prevent contact with the grinding blades. This device lets the coffee beans drop
but avoids the insertion of the fingers.
30
How to properly fitting the protections against moving parts and hazards that
may exist if these parts are disassembled:
Before turning the coffee grinder, make sure the Hopper (2) is well- attached and fixed.
Special precautions during installation:
Place the grinder on a flat and stable surface, in an appropriate distance from a
ground mains outlet (approx. 110cm.), distanced from running water and heat sources.
Minimum clearances:
Width: 20cm. on both sides.
Depth: 20cm in front of and behind the grinder.
Height: 30cm. on the top of the grinder.
The electrical installation must be done by qualified personnel and following
safety indications:
Make sure the electrical data on the coffee grinder's specification plate (see
section 37 of this manual), connect the grinder to a grounded mains outlet
meeting the country's regulation, protect the power source with a suitable
magneto-thermal switch, having a suitable differential relay, make sure the
mains wiring is suited to the device's power consumption, do not use cable
extensions, adaptors or multiple-switch boards. If the power cord is damaged, it
must be replaced.
Do not operate the coffee grinder while barefoot or with wet or damp hands or
feet, avoid wetting the outer surface of the coffee grinder, avoid the penetration
EN
31
Publicidad
