Publicidad
Idiomas disponibles
Idiomas disponibles
12
Electrical Wiring
The electrical installation of your coffee
grinder should be left to qualified person-
nel, always adhering to the following safety
indications:
a) Make sure the electrical data on the coffee
grinder's Specifications Plate (see section 37
of this manual) match your mains power.
b) The coffee grinder must be connected to
be agrounded mains outlet meeting your
country's regulations.
Non-fulfilment of this requirement may
constitute a serious hazard to your health.
The manufacturer may not be held liable for
any injuries or harm caused by a non-groun-
ded mains power outlet.
c) The power source must be protected by
means of a magneto-thermal switch suited
to the power required by the coffee grinder,
as indicated on the grinder's Specifications
Plate (see section 37 of this manual).
d) There should be a differential relay suited
to the characteristics of the mains wiring.
e) Make sure the mains wiring is suited to
the device's power consumption.
f) Do not use cable extensions, adaptors or
multiple-switch boards or plugs to connect
the coffee grinder to the mains outlet.
g) If the power cord is damaged, it must be
replaced by the manufacturer or its after-sa-
les service or by qualified personnel in order
to avoid a hazard.
44
13
Before Using the Coffee
Grinder
Before using the coffee grinder for the first
time, follow the instructions below to load
coffee beans:
a) Make sure the coffee bean hopper (2)
is correctly placed and attached by the
lockscrew (3) to the grinder adjustment
platen (4).
b) Close the trap (5) preventing the beans
from entering the grinder chamber.
(b) / (d)
c) Lift the hopper lid (1), fill the hopper with
coffee beans (2) and close the lid.
d) Slide the trap (5) to its outer position
letting the beans drop into the grinder
chamber.
The manufacturer may not be held liable for
injuries or harm to persons and/or animals,
or material damages resulting from the
incorrect installation of the coffee grinder
or failure to comply with any of the above
indications.
14
Grinding coffee beans
Turn on the coffee grinder using the On/Off
switch (11).
The beans will pass through the grinder
and the ground coffee will fit the ground
coffee dispenser (8).
When the ground coffee dispenser (8) is
full, stop the coffee grinder using the On/
Off switch (11).
ONLY FOR MODELS WITH AUTOMATIC STOP:
After starting the coffee grinder using
the On/Off switch (11), the machine stops
auto- matically when the ground coffee
dispenser (8) drops to a certain level, the
coffee grinder starts up automatically,
refills the dispenser (8) and shuts down
automatically once the dispenser is full.
15
Grinding coffee beans
a) Place the filter holder of the coffee ma-
chine against the Seal-saver (12), located
right below the dispenser's ground coffee
outlet (8).
b) Pull the dispenser handle (14) towards
you to obtain a single measure. Release the
handle for it to return to its position.
c) Place the filter holder of the coffee ma-
chine under the ground coffee press (10) and
press upwards to pack the ground coffee.
If you want to obtain the same dose of
ground coffee every time, try to keep the
dispenser (8) of ground coffee almost full.
(Remember that this operation is automatic
in models with the automatic stop).
EN EN
45
Publicidad
