Publicidad
Idiomas disponibles
Idiomas disponibles
ASSEMBLY INSTRUCTIONS
6. Connect the air supply hose to the male air
plug (See Figure 6), making sure it is
completely seated and secure. Set the
working pressure at 90 PSI for best tool
performance.
NOTE:
Working pressure is the amount of
air pressure the tool sees when spinning
freely.
3/8-IN AIR RATCHET
1. Remove plastic air inlet protective cap
from air inlet (E2) (See Figure 1).
2. Insert the male plug into the air inlet (E2).
Tighten the male plug (I) by turning it
clockwise using a 9/16 in. (14 mm)
wrench (not included) for an air tight
connection. DO NOT OVERTIGHTEN.
(See Figure 2).
NOTE:
Use threaded sealant tape
on the threading of the male plug (I).
6
1
2
15
E2
Publicidad
