Publicidad
Idiomas disponibles
Idiomas disponibles
ASSEMBLY INSTRUCTIONS
6. Connect air supply hose to the male plug.
Set the working pressure at 90 PSI for
best tool performance (See Figure 6).
AIR HAMMER
1. Remove plastic air inlet protective cap
from air inlet (E3) (See Figure 1).
2. Insert the male plug into the air inlet (E3).
Tighten the male plug (I) by turning it
clockwise using a 9/16 in. (14 mm)
wrench (not included) for an air tight
connection. DO NOT OVERTIGHTEN
(See Figure 2).
NOTE:
Use threaded sealant tape
on the threading of the male plug.
6
1
2
17
E3
Publicidad
