Selco Genesis 3200 Instrucciones De Uso página 43

500 Allows the selection of the required graphic interface:
XE (Easy Mode)
XA (Advanced Mode)
XP (Professional Mode)
Allows access to the higher set-up levels:
USER: user
SERV: service
SELCO: Selco
551 Lock/unlock
Allows the locking of the panel controls and the inser-
tion of a protection code (consult the "Lock/unlock"
section).
552 Buzzer tone
Permits adjustment of the buzzer tone.
Minimum Off, Maximum 10, Default 10
553 Contrast (LCD 4.7")
Permits adjustment of the display contrast.
Minimum -20, Maximum +20
601 Regulation step
Allows the regulation of a parameter with a step that
can be personalised by the operator.
Minimum 1, Maximum Imax, Default 1
602 External parameter CH1, CH2, CH3, CH4
Allows the management of external parameter (mini-
mum value, maximum value, default value, parameter
selected).
(Consult the "External controls management" section).
606 U/D torch
Allows the management of the external parameter
(CH1) (parameter selected).
705 Circuit resistance calibration
Lets you calibrate the system.
Press the encoder knob to access parameter 705.
Place the tip of the wire guide in electrical contact with
the work piece.
Press and hold the torch trigger for at least 1 s.
751 Current reading
Allow the real value of the welding current to be dis-
played.
752 Voltage reading
Allows the real value of the welding voltage to be dis-
played.
755 Gas flow reading
Allows the real gas flow value to be displayed.
757 Wire speed reading
Allow the value of the motor encoder 1 to be displayed.
758 Robot movement speed
Allows the arm movement speed of a robot or an auto-
mation device to be displayed.
760 (Motor) Current reading
Allow the real value of the (motor) current to be dis-
played.
761 Wire speed reading
Allow the value of the motor encoder 2 to be displayed.
762 (Motor) Current reading
Allow the real value of the (motor) current to be dis-
played.
763 Wire speed reading
Allow the real value of the wire speed to be displayed.
764 Coolant flow reading
Allow the value of the coolant flow reading.
765 Coolant temperature reading
Allow the real value of coolant temperature reading to
be displayed.
801 Guard limits
Allows the setting of the warning limits and of the guard
limits.
Allows the accurate control of the various welding
phases (consult the "Guard limits" section).
3.7 Synergic curves screen
1 General
Allows the selection of the required welding method.
1
It allows the selection of:
Synergic welding method
Makes it possible to use a series of pre-settings
(synergic curves) available in the memory of the
system.
The changing and correction of the initial set-
tings proposed by the system is allowed.
Manual welding method
Allows the manual setting and regulation of
each individual welding parameter (MIG/
MAG).
Select however one of suggested synergies (5-6) in
order to take advantage of ignition potentiality,
closing arc features....
2/3
Lets you select:
- type of filler material
- gas type
4
Lets you select:
- wire diameter
5
- Type of filler material
- Gas type
6 Wire diameter
7 Header
(See the "Main screen" section).
NO PROGRAM
Indicates that the selected synergic program is not avail-
able or is not consistent with the other system settings.
43