Truper ROTO-1/2A8-2 Instructivo página 15

Technical Data
Code
Description
Chuck
Voltage
Frequency
Current
Power
Speed
Drill Capacity
Duty Cycle
Conductors
Insulating
WARNING
Avoid the risk of electric shock or severe injury. When the power cable gets damaged
it should only be replaced by the manufacturer or at a
The build quality of the electric insulation is altered if spills or liquid gets into the tool while in use.
Do not expose to rain, liquids and/or dampness.
Before gaining access to the terminals all power sources should be disconnected.
WARNING
Power Requirements
WARNING Tools with double insulation and reinforced insulation
eliminate the need of a grounded power cord with three prongs or a grounded
power connection.
WARNING
When using an extension cable, verify the gauge is enough for
the power that your product needs. A lower gauge cable will cause voltage drop in
the line, resulting in power loss and overheating. The following table
shows the right size to use depending on cable's length and the ampere
capability shown in the tool's nameplate. When in doubt use the next
higher gauge.
Ampere
Capacity
from 0 A and up to 10 A
from 10 A and up to 13 A
from 13 A and up to 15 A
from 15 A and up to 20 A
Drill: 0 - 3 000 RPM
30 minutes work per 15 minutes idle. Maximum 3 hours per day.
H05VV - F 2 X 0.75 mm² with insulating temperature of 221 °F
Class II
Number of
Conductors
3 (one grounded)
* It is safe to use only if the extensions have a built-in artifact for over current protection.
AWG = American Wire Gauge. Reference: NMX-J-195-ANCE-2006
ROTO-1/2A8-2
15347
Hammer drill
1/2"
220 V
50 Hz / 60 Hz
2,95 A
0.9 Hp
Hammer drill: 0 - 48 000 Strokes/minute
Metal: 1/2" | Concrete: 1/2" | Wood: 1"
IP Grade
Power Cord Grips used in this product: Type Y.
Tool Build Quality: Reinforced insulation.
Thermal insulation on motor winding: Class E.
Authorized Service Center.
Extension gauge
from 6' to 49'
18 AWG( * )
16 AWG
14 AWG
8 AWG
IP20
| higher than 49'
16 AWG
14 AWG
12 AWG
6 AWG
ENGLISH
3