Publicidad
Idiomas disponibles
Idiomas disponibles
Start Up
Bit fitting
• Put the bit into the chuck until it stops.
Fasten with the chuck wrench and tighten
alternately the chuck into each of the orifices.
WARNING
Clean burrs and any other foreign
objects from the drill bit and drill bit, otherwise the drill bit
may not be tight and cause serious personal injury.
Turn on and operation control
• Intermittent operation:
Connect the plug into the power inlet.
Press the switch (A) to start the hammer drill.
To stop, just release the switch.
• Continuous Operation:
Connect the plug into the power inlet.
Press the switch (A) and block it pressing the continuous use button (B).
To stop, press and then, release the switch.
Speed control
• The tool can run in different speeds. Select by adjusting
speed control (C) in the switch.
• Turn speed control clockwise to increase the hammer
drill speed and torsion.
• Turn counterclockwise to lessen speed and torsion.
Changing from hammer drill to drill
• To drill concrete, floor tile or materials of similar
hardness, turn the impact-rotation selector (D) completely
into the IMPACT (
) position (pointing towards the
chuck). The bit will simultaneously impact and rotate onto
the material.
• To drill metal, wood or plastic, move the impact-rotation
selector completely into the DRILL (
(pointing towards the chuck). The bit will rotate onto the
material.
WARNING
Do not try to drill metal; wood or plastic
with the selector impact-rotation into IMPACT (
position (pointing towards the chuck) mode. Otherwise
the tool efficiency will lessen and the bit tip would get
damaged.
Rotation direction
• The rotation direction button is located on both sides of
the hammer drill (E).
• To make the drill turning forwards and drill, press the
rotation direction button with the arrow pointing towards
the chuck.
• To make it reversible press the rotation direction button
with the arrow pointing towards the hammer drill handle.
• The reverse rotation enables the hammer drill to loosen
screws and nuts turning the hammer drill into a
screwdriver. When using the hammer drill in the
screwdriver mode do not exercise too much pressure onto
the switch.
• Changing the rotation direction can only be carried out
when the switch is not pressed.
Bit
) position
)
Chuck
Chuck
wrench
B
C
A
D
Rotation selector
button in the
drilling position.
ENGLISH
E
7
Publicidad
