Publicidad
Idiomas disponibles
Idiomas disponibles
EN
Operating instructions
8. Cleaning
To clean the motor, hold the tool firmly
ventilation slots regularly and thoroughly, (Figure 2).
9. Troubleshooting
Mains powered machines:
•
Overload protection: when there is a MAJOR reduction in load speed.
temperature is too high! Allow the machine to run at idle speed until it has cooled down.
•
Overload protection: when there is a SLIGHT reduction in load speed.
overloaded. Reduce the load before continuing to work.
•
S-automatic safety shutdown: when the power tool SWITCHES OFF automatically.
the slew rate of the current is too high (for example, if the machine suddenly seizes or
kickback occurs), the machine switches off. Release the Safety Switch to switch off the
machine. Switch it on again and continue to work as normal.
•
Machine is running but MBX
damaged and needs to be replaced. See chapter 11, Repairs.
10. Accessories
Use only genuine MontiPower
Use only accessories listed in these operating instructions or expressly approved by the
manufacturer. For a complete range of accessories, see
11. Repairs
Repairs to electrical tools must be carried out by qualified electricians ONLY! Contact
your local MontiPower
repairs.
You can download specific repair instructions and a list of spares and assemblies from
www.montipower.com.
14
F
F
and blow compressed air through the rear
®
Belt does not rotate.
®
accessories.
®
representative if you have MontiPower
MBX
Less contact pressure = longer service
life and higher performance.
Note that excessive pressure will lead
to damaging the MBX
breakage of the tooth belt.
The toothbelt is broken or heavily
www.montipower.com.
®
power tools requiring
®
ULTIMATE ELECTRIC
®
Belt and even
The motor
The tool is
If
Publicidad
