Publicidad
Idiomas disponibles
Idiomas disponibles
®
MBX
ULTIMATE ELECTRIC
n)
Keep bystanders a safe distance away from work area. Anyone entering the work
area must wear personal protective equipment.
a broken accessory may fly away and cause injury beyond the immediate area of
operation
o)
Hold power tool by insulated gripping surfaces only when performing an operation
where the MBX
Belt contacting a "live" wire may make exposed metal parts of the power
tool "live" and could cause an electric shock.
p)
Never lay the power tool down until the accessory has come to a complete stop.
spinning accessory may grab the surface and pull the power tool out of your control.
q)
Do not run the power tool while carrying it at your side.
spinning MBX
r)
Regularly clean the power tool's air vents (Figure 2).
the dust inside the housing and excessive accumulation of powdered metal may
cause electrical hazards. The air vent cap may be removed for cleaning,
use non-metallic objects only.
s)
Do not operate the power tool near flammable materials.
materials.
t)
Do not use any liquid coolants.
electrocution or shock.
4.2
Kickback and Related Warnings
Kickback is a sudden reaction to a rotating wheel which can cause rapid stalling of
the rotating MBX
in the direction opposite of the MBX
a)
Maintain a firm grip on the power tool and position your body and arm to allow
you to resist kickback forces. Use auxiliary handle, if provided, for maximum
control over kickback or torque reaction during start-up.
control torque reactions or kickback forces if proper precautions are taken.
b)
Never place your hand near the rotating MBX
kickback over your hand.
c)
Do not position your body in the area where power tool will move if kickback occurs.
Kickback will propel the tool in direction opposite to the MBX
the point of snagging.
d)
Use special care when working corners, sharp edges etc. Avoid bouncing and
snagging the MBX
the rotating MBX
Belt and even breakage of the tooth belt.
e)
Do not attach any other belt or belt Adaptor System than that provided by the
manufacturer.
®
Belt may contact hidden wiring or its own cord.
®
Belt could snag your clothing, pulling the accessory into your body.
Using water or other liquid coolants may result in
®
Belt which in turn causes the uncontrolled power tool to be forced
®
Belt.
Corners, sharp edges or bouncing have a tendency to snag
®
Belt and cause loss of control or kickback, damage to the MBX
Fragments of workpiece or of
The motor's fan will draw
®
Belt's rotation.
®
Belt.
Accessory may
®
The MBX
Accidental contact with the
Sparks could ignite these
The operator can
®
Belt's movement at
EN
The
®
7
Publicidad
