ROBLIN GLISS Manual Del Usuario página 24

AIR OUTLET – RECIRCULATION VERSION
• Unfasten the 2 screws fixing the upper bracket 7.2.1.
• Fasten the air outlet connector 15 in its place, using the 2
screws removed as above.
• Join the Connector 15 to the Hood canopy outlet using a rigid
or flexible pipe ø150 mm, selection of which is at the
discretion of the installation technician.
• Make sure that the Activated charcoal odour filter has been
fitted.
ELECTRICAL CONNECTION
• Connect the hood to the mains through a two-pole switch hav-
ing a contact gap of at least 3 mm.
• Remove the grease filters (see paragraph Maintenance) being
sure that the connector of the feeding cable is correctly inserted
in the socket placed on the side of the fan.
• Fix the corner element 15 to the hood canopy using the screws
12d (2.9 x 9.5) provided.
Upper chimney
• Open the two side pieces out slightly, hook them up behind the
brackets 7.2.1 and bring them back together again until they
are in contact.
• Fix them to the sides of the Brackets using 4 Screws 12c (2.9 x
9.5) provided.
• Make sure that the outlet from the Connector extensions is in
correspondence with the Chimney openings.
Lower chimney
• Open out the two Chimney side flaps, hook them up between
the upper chimney and the wall and then close them up again
until they touch.
• Fix the lower part to the Hood canopy at the sides, using 2
screws 12c (2.9 x 9.5) provided.
EN
Fitting the Chimney
15
2
24
4