Publicidad
Idiomas disponibles
Idiomas disponibles
Installation instructions
3. Installation preparation
Unpack installation materials and accessories.
See the Installation preparation section on Installation Requirement chapter.
4. Attaching the anti-tip-bracket
WARNING
To keep the unit from tipping forward, an anti-tip bracket must be installed. Before
attaching the bracket, ensure that no electrical wiring or plumbing is in the area where the
screws will penetrate. One such bracket per appliance is required.
CAUTION
Always wear safety glasses and other necessary protective devices or apparel when
installing or working with anchors.
Dacor does not recommend that you anchor the anti-tip bracket in light-weight masonry
(e.g., block, brick) or in new, uncured concrete.
Make sure the wall or the cabinet that the brackets are studded in has enough strength to
withstand the safety load.
Wooden Wall
Concrete Wall
The anti-tip brackets must extend at least 2" (50 mm) over the appliance to secure the
appliance. If this minimum length cannot be observed for structural conditions it is
possible to do this by fastening a spacer (wood) behind the anti-tip angle.
For 36" models, place 2 anti-tip brackets at intervals and fix them with 3 screws per
bracket on a wooden wall, or with 3 screws and 3 holder-locks per bracket on a concrete
wall. For the other models, you can use one anti-tip bracket for the intended purpose.
30
English
Dacor_OneDoor_BRR9000M_IM_DA68-03621B-07_EN.indd 30
1. Bracket height is measured from the
floor and depends on the cabinet
height.
M4x35
NOTE
Bracket height
= Cabinet height – 4 3/32" (104 mm)
2. Attach the anti-tip brackets. Ensure the
M4x35
screws hold the bracket tightly.
ø6x30
2020-11-16
4:25:15
Publicidad
