Gaggenau VG 295 20 Serie Manual Del Propietário página 9

Individual parts of the burners
Ensure that the individual parts of the burners are fitted
in the correct position and are straight; otherwise, this
may result in ignition problems or problems during
operation.
Fit the burner head and the burner ring in such a way
that the latches on the lower section of the burner click
into place in the corresponding slots. The alignment of
the burner head and the burner ring is not important.
Note: If the burner parts are fitted at an angle, the
appliance will not work.
Individual parts of the standard output burner and
high output burner
( Burner cap
0
Burner ring
8
Burner head
@
Ignition plug
H Thermocouple
Familiarising yourself with your appliance
Setting up the burner
The torch parts should be fitted and hung up, otherwise
it may cause malfunction in the ignition state or during
operation. Fit the burner head so that the thermocouple
in the corresponding recess is positioned at the tip of
the burner. The snap-on lock must be snapped in place
at the corresponding recess on the burner head on the
burner ring.
en
9