Amano American SANDERS EDGER DOLLY Manual Del Usuario página 5

EN
1. Insert the seat frame stem in the base frame tube. Be sure the seat
cushion is towards the closed-end of the base frame and the chest
pad is towards the open end of the base frame.
WARNING: Any other assembly orientation will make the Edger Dolly
unstable when attempting to sit on it.
2. Secure seat frame in the middle hole with the clevis pin. Secure
clevis pin with the cotter pin.
Machine Setup
3. Connect the chest pad frame to the seat frame. Position it
approximately 2", (5 cm), from the seat cushion. Secure the location
by tightening the thumb screw.
4. Position an edger in front of the Edger Dolly. The edger should be in
front of the open end of the base frame. Secure the edger cord with
cord support of the Edger Dolly.
5. Sit on the seat cushion and lean forward on the chest pad.
WARNING: Always hold onto the Edger Dolly as you sit down to
keep it from rolling or tipping.
6.Grasp the edger handles, but do not operate the edger. Adjust the
seat frame height and the chest pad position to the desired location.
WARNING: Do not over extend the chest pad. The maximum gap
between the chest pad and the seat cushion is 5", (12,7 cm).
5