Publicidad
Idiomas disponibles
Idiomas disponibles
NOTE: A Phillips screwdriver is required.
1) Remove all the contents from inside of the vacuum cleaner container.
2) Turn the container upside down and insert the feet with casters into the slots and apply
pressure until they click into place (Fig. 1).
3) Insert the wheel axle into the rear wheel housing on the base. Insert a washer onto the axle
followed by the rear wheel and another washer. Insert the wheel retaining pin into the hole on
the end of the axle to lock into place. Push fit the hub cap onto the wheel. Repeat the same
steps on the other end of the axle (Fig. 2).
4) Attach the carry handle into the slots located on the top of the power head. Secure them with
supplied screws (Fig. 3).
5) To position the hose storage rack, insert one end into the channel on the side of the power
head, making sure it is secured in place. Apply inward pressure to the other side and insert it
into the opposite channel (Fig. 4 & 5).
6) Your vacuum cleaner comes ready for dry vacuum cleaning with the cartridge filter
pre-installed. If the cartridge filter is not installed, refer to page 13.
7) Optionally, for improved dust filtration and hygienic disposal, fully fit the dust bag flange onto
the inlet stub (Fig. 6).
NOTE: The dust bag is for dry pick-up only.
8) For wet vacuuming and carpet shampoo cleaning, replace the cartridge filter with the foam
filter supplied. Do not use a dust bag when wet vacuuming or carpet shampoo cleaning. If the
foam filter is not installed, refer to page 13.
9) Secure the power head back on the container using the 2 side latches.
10) Insert the detergent connecting hose into the detergent tank inlet coupling (Fig. 7).
11) Insert the locking end of the hose into the suction port of the container and turn clockwise to
lock into place. Connect the detergent delivery tube onto the detergent outlet coupling located
in the front of the power head (Fig. 8).
12) Choose the desired accessories and/or the extension wand and push fit onto the remote
control handle (Fig. 9).
ASSEMBLY
11
GB
Publicidad
