Vacmaster VK1330PWR Manual página 16

GB
WARNING!
CARRYING OUT ANY MAINTENANCE.
1) Remove the suction hose from the vacuum. Press down the latch on the detergent outlet
coupling and unplug the delivery tube connector from the vacuum (Fig. 30).
2) Keep all safety devices, air vents and the motor housing free of dirt and dust. Use a soft, dry
brush to clean the equipment regularly.
3) Clear all dirt or debris from the collection tank after each use. Allow to dry before replacing the
power head. Do not use cleaning agents or solvents; these may damage the appliance.
4) Check the hose, attachments, and power cord to verify that they have not been damaged, or
any debris is trapped and blocking airflow.
1. Cleaning Cartridge Filter
1) Remove the filter and clean by gently tapping or brushing dirt off. For optimal performance it is
recommended to replace the old filter with a new filter regularly.
2) If necessary, use a mild soap and water solution to wash cartridge filter and rinse with clean
water. Allow the filter to air dry before re-installing.
2. Cleaning Foam Filter
Remove the foam filter and use a mild soap and water solution to wash and rinse with clean water
(Fig. 31). Allow the filter to air dry before installing and using again.
3. Cleaning & Replacing Exhaust Filter
1) Unlock the exhaust filter cover by lifting the locking tab upwards to the release. Pull the cover
out (Fig. 32).
2) Remove the exhaust filter from the vacuum and clean by gently tapping or brushing off dirt. For
optimal performance it is recommended to replace the old filter with a new filter regularly (Fig.
33).
3) Install the cleaned or new filter. Then insert the filter cover tabs into the upper slots and lock the
filter cover into place.
4. Changing the Battery in Remote Control Handle
NOTE: Only replace the battery with a 27A 12V Alkaline battery.
1) Pry off the battery cover and remove it from the battery compartment (Fig. 34).
2) Remove the battery from the battery compartment. Insert the new battery with the terminals in
the direction as shown (Fig. 35).
3) Position the battery cover in the angle of inclination as shown. Then insert it into the slot on the
battery compartment and press down the battery cover to click into place (Fig. 36 & 37).
MAINTENANCE
REMOVE THE POWERCORD FROM THE POWER SUPPLY BEFORE
16