Vacmaster VK1330PWR Manual página 17

WARNING!
TROUBLESHOOTING.
Cleaning Performance
Vacmaster vacuum cleaners are tested for endurance. If your motor is operating, then the most
likely cause for a loss in suction is a blockage or an opening in the vacuum.
To maintain a high cleaning performance from your machine, it is important to replace or clean
cartridge filters as necessary. A performance drop with clean filters can only be caused by a
blockage in the tools or the hose.
PROBLEM
No power.
The appliance
Functional fault in the power cord,
does not work.
switch, or motor.
The cartridge filter is missing or
damaged.
Dust is escaping Misuse the cartridge filter when
from the motor wet vacuuming, causing the
cover. damage of cartridge filter.
Misuse the foam filter when dry
vacuuming.
Suction nozzle, hose, or tank inlet
is blocked.
Low suction power
Cartridge filter is blocked.
and high operating
noise / vibrations.
Float valve has closed.
Detergent mode is not selected.
Detergent tank is empty.
No solution
Incorrectly fitted pipes.
spraying out.
The water pump inside the power
head overheats.
Foam is escaping
Misuse the high foaming shampoo
from the air outlet
detergent.
on motor cover.
The battery is depleted.
The remote control
The remote control is not paired
does not work.
correctly.
TROUBLESHOOTING
TO REDUCE THE RISK OF ELECTRIC SHOCK, UNPLUG BEFORE
POSSIBLE CAUSE
Check the power supply and fuse.
Have the damaged part checked by
qualified personnel or contact the after
sales helpline.
Put in a cartridge filter or replace it.
Replace the damaged cartridge filter
with a new one when dry vacuuming.
Replace the foam filter with the cartridge
filter.
Check the suction nozzle, hose, and
tank inlet for obstructions.
Remove the cartridge filter and clean.
Empty the container of any liquid waste
and ensure the float valve located
underneath the filter is able to move freely.
Press the detergent mode button.
Add more detergent.
Check fittings and connections. Ensure
there are no kinks in tubes.
Let the vacuum cool down to reach a
normal temperature, then re-start the
vacuum.
Replace with low foaming shampoo
detergent.
Replace the old battery with a new one.
Reset the remote control follow the
instructions on page 12.
17
SOLUTION
GB