3. Press OK again to confirm.
9.6
Program Siren menu – other options
Learn Siren
To add an outdoor bell box, indoor bell box or universal receiver... it should be programmed first by the control
panel, so that the control panel can communicate with these auxiliary devices.
Before adding one of these auxiliary devices, you need to add at least one other device first (a door contact,
PIR detector or remote control).
To add an outdoor or indoor siren:
1. Put the device or devices you want to add in learn mode.
2. Enter Program mode, go to Devices+/-, select Program Siren and press OK.
3. Use the up and down arrows to select Learn Siren and press OK.
The control panel will then sound a long beep and transmit learning code to all devices simultaneously.
o
The outdoor siren will respond by activating its siren and strobe light momentarily.
o
4. Place these auxiliary devices out of Learn mode. Adding them into the system is completed.
Siren Tamp. On - Siren Tamp. Off
The outdoor siren tamper switch can be enabled and disabled remotely.
This is used especially when replacing siren battery.
To disable the siren tamper: select Siren Tamp.Off and press OK.
•
All added sirens will temporarity lose their tamper protection simultanously.
•
To enable the siren tamper: select Siren Tamp.Off and press OK.
The tamper protection will be set simultaneously for all sirens.
Confirm On - Confirm Off
When set to on, the outdoor siren will sound a confirmation beep when arming or disarming the system.
•
When set to off, the outdoor siren will not sound a confirmation beep when arming or disarming the
•
system.
Select Confirm On or Confirm Off and press OK.
•
Entry Snd On - Entry Snd Off
Enables or disables entry delay warning beeps on the siren when you enter the house.
Select Entry Snd On or Entry Snd Off and press OK.
10. Other configuration functions
SMS Editor
The control panel editing the SMS message that will be sent to your mobile phone when an alarm occurs.
V. 04 – 11/02/2016
CTC1000
24
©Velleman nv