Publicidad
Idiomas disponibles
Idiomas disponibles
BSF HP
The electrical system must be installed by a qualified technician according to the local regulations and in accordance
with the applicable regulations in the building.
The system heating element must not be activated with the hot water tank empty! In this case the warranty
is voided.
For the heating element electrical connection it is necessary to (see fig. 3):
• Remove the cover "D" by undoing the fastening screws.
• For the electrical connection it is necessary to use a cable "B" 3x2.5 mm
• Run the end of the cable through the cable gland and connect the wires to the terminal block.
• Refit the cover.
The hot water tank has a safety thermostat (ref. T in fig. 3) which cuts in if the temperature exceeds 93°C.
2.5 Startup
After installation, fill the hot water tank with water for DHW use and for heating, proceeding as follows.
• Carry out filling of water for heating and vent the system.
• Carry out filling of water for domestic hot water use by means of the cold water inlet and vent by opening a hot water
draw-off point.
• Insert the probe ("solar" or "generator" according to the type of installation) in the appropriate well.
• Start the generator.
fig. 3
Cod. 3540000190 - Rev. 06 - 06/2023
(for 2.0 kW heating element).
2
Live
Neutral
EN
43
Publicidad
