Benelli 502C Manual Del Propietário página 113

Instrument and control functions
Turn signal indicator lights "
" "
Each indicator light will ash when its cor-
responding turn signal lights are ashing.
EN
Neutral indicator light "N"
This indicator light comes on when the
3
transmission is in the neutral position.
High beam indicator light "
This indicator light comes on when the
high beam of the headlight is switched
on.
Engine trouble warning light "
This warning light comes on if a problem
is detected in the engine or other vehicle
control system. If this occurs, have a Be-
nelli dealer check the on-board diagnostic
system.
The electrical circuit of the warning light
can be checked by turning the key to " ".
The warning light comes on and stays on
by turning the key to " ".
If the warning light does not come on
initially by turning the key to " " or if the
warning light stays on after the engine is
started, have the vehicle checked by a Be-
nelli dealer.
Tachometer
" and
The tachometer shows the running tur-
nover of the engine so that the rider can
keep it within the ideal power range.
Coolant temperature
This shows the temperature of the coo-
lant.
The coolant temperature varies with chan-
ges in the weather and engine load. if the
"warning lamp" ashes, stop the vehicle
then stop the engine and let it cool.
"
WARNING
Do not continue to operate the engine
"
if it is overheating.
Digital clock
Shows the time in hours and minutes.
Digital clock setting
To adjust the clock, activate the key switch
and immediately press and hold the set-
ting button, once released, the hour digit
will begin to ash on the meter.
Brie y press the Set button to change the
number, or long press to move the a-
shing digit
to the next position to continue the
adjustment.
Fuel gauge
The digital fuel gauge shows the capacity
of the fuel tank. As the fuel level drops, the
lines on the gauge will become closer and
closer to the "E" reserve area.
As soon as the nal line starts to lash, there
is an autonomy of about 3.2 litres of fuel.
3 - 4