Lindy 38349 Manual De Usuario página 5

User Manual
Installation and Operation
Transmitter Front and Rear
1.
Power LED: Indicates power.
2.
EDID Dip-Switch:
- COPY – Copy the EDID of the HDMI OUT port of the Receiver.
- STD – Set Default EDID 1080p 2CH.
3.
SERVICE: Reserved for firmware updates.
4.
24V DC: Connect the 24VDC 1A PSU to an AC wall outlet and securely connector to the Transmitter
or Receiver. This is only required at one side of the installation.
5.
CAT OUT: HDBaseT output port, connect a compatible HDBaseT Receiver using a single Cat.6 or
above cable for all data signals. Please do not connect to a network port.
6.
Link Indicator LED:
- Illuminating when Transmitter and Receiver are connected.
- Flashing when the connection between Transmitter and Receiver is not stable.
- Not illuminated when there is no connection between Transmitter and Receiver.
7.
Data Signal Indicator LED:
- Illuminating when HDMI signal is with HDCP.
- Flashing when HDMI signal is without HDCP.
- Not illuminated when there is no HDMI signal.
8.
HDMI IN: Connect to an HDMI source device.
9.
TOSLINK OUT: Connect to a digital TosLink (Optical) Output using an optical cable.
10.
IR IN: Connect the supplied IR Receiver cable for IR signal reception. Ensure the remote being used
is within the direct line-of-sight of the IR Extender.
11.
IR OUT: Connect the supplied IR Transmitter cable for IR signal transmission. Place the IR Transmitter
in direct line-of-sight of the equipment to be controlled.
12.
RS-232: Connect to a PC, serial controller or serial device via a phoenix block 3-way connection for
the pass-through transmission of RS-232 commands.
English