Lindy 38349 Manual De Usuario página 6

User Manual
Receiver Front and Rear
1.
Power LED: Indicates power.
2.
AUDIO Dip-Switch:
- HDMI ARC – The audio returned from the HDMI OUT port of the Receiver will be output through
the HMDI IN and TOSLINK OUT ports on the Transmitter. A source with ARC function connected to
HDMI IN port on the Transmitter is needed.
- TOSLINK IN – The audio returned from the TOSLINK IN port of the Receiver will be output through
the HMDI IN and TOSLINK OUT ports on the Transmitter. If a non-ARC source is connected to HDMI
IN port on the Transmitter, ARC function is disabled and the audio from the TOSLINK IN port of the
Receiver will be output through the TOSLINK OUT port on the Transmitter.
3.
SERVICE: Reserved for firmware updates.
4.
24V DC: Connect the 24VDC 1A PSU to an AC wall outlet and securely connector to the Transmitter
or Receiver. This is only required at one side of the installation.
5.
CAT IN: HDBaseT input port, connect a compatible HDBaseT Transmitter using a single Cat.6 or
above cable for all data signals. Please do not connect to a network port.
6.
Link Indicator LED:
- Illuminating when Transmitter and Receiver are connected.
- Flashing when the connection between Transmitter and Receiver is not stable.
- Not illuminated when there is no connection between Transmitter and Receiver.
7.
Data Signal Indicator LED:
- Illuminating when HDMI signal is with HDCP.
- Flashing when HDMI signal is without HDCP.
- Not illuminated when there is no HDMI signal.
8.
HDMI OUT: Connect to an HDMI display.
9.
TOSLINK IN: Connect to a digital audio source using a TosLink (Optical) cable.
10.
IR IN: Connect the supplied IR Receiver cable for IR signal reception. Ensure the remote being used
is within the direct line-of-sight of the IR Extender.
11.
IR OUT: Connect the supplied IR Transmitter cable for IR signal transmission. Place the IR Transmitter
in direct line-of-sight of the equipment to be controlled.
12.
RS-232: Connect to a PC, serial controller or serial device via a phoenix block 3-way connection for
the pass-through transmission of RS-232 commands.
English