Stihl RME 339.0 C Manual De Instrucciones página 36

English
Fault
The lawn mower vib‐
rates excessively
during operation.
The grass has not
been cut cleanly or
the lawn is yellow.
18 Specifications
18.1 Lawn Mower
STIHL RME 339.0 C
– Power supply: See rating plate
– Frequency: See rating plate
– Power input: 1200 W
– Weight (m) with grass catcher box: 15 kg
– Maximum grass catcher box capacity: 40 l
– Working width: 37 cm
– Speed (n): 3200 rpm
– Electrical protection class: II
– Electrical type of protection: IPX4
18.2 Blade
– Minimum thickness a: 1.6 mm
– Maximum grinding limit b: 5 mm
– Sharpening angle c: 30°
18.3 Sound Values and Vibration
Values
The K value for the sound pressure level is
1 dB(A). The K value for the sound power level is
36
Cause
The blade is blocked.
The blade fastening screw is loose.
The blade is not correctly balanced.
The blade is blunt or worn.
The resistance at the blade is too
great.
Remedy
► Mow shorter grass.
► Sharpen the blade,
► Use an extension cable with the cor‐
rect length,
► Use an extension cable with an ade‐
quate cable cross section,
► Clean the lawn mower,
► Tighten the screw,
► Sharpen and balance the blade,
15.3.
► Sharpen and balance the blade,
15.3.
► Set a higher cutting height,
► Mow shorter grass.
0.9 dB(A). The K value for the vibration value is
0.6 m/s².
– Sound pressure level L
ance with EN IEC 62841-4-3: 79 dB(A)
– Guaranteed sound power level L
ured in accordance with 2000/14/
EC / S.I. 2001/1701: 93 dB(A)
– Vibration value a
hv
with EN IEC 62841-4-3, handlebar: 1.20 m/s²
The indicated vibration values were measured in
accordance with a standardised test method and
can be used for the purpose of comparing electri‐
cal appliances. The actual vibration values that
occur may deviate from the indicated values,
depending on the type of application. The indica‐
ted vibration values can be used for an initial
assessment of the vibration load. The actual
vibration load must be assessed. Times during
which the electrical appliance is switched off,
along with times during which it is switched on
but running without load, can also be taken into
consideration.
For information on compliance with Employers'
Vibration Directive 2002/44/EC and
S.I. 2005/1093, see www.stihl.com/vib.
18.4 REACH
REACH is an EC regulation and stands for the
Registration, Evaluation, Authorisation and
Restriction of Chemical substances.
For information on compliance with the REACH
regulation see www.stihl.com/reach.
18 Specifications
15.3.
18.
18.
14.
15.2.2.
measured in accord‐
pA
meas‐
WAd
measured in accordance
0478-121-9926-A
10.2.