Hilti GX 2 Manual De Instrucciones Original página 20

Wear a hard hat
Return waste material for recycling
The power tool supports near-field communication (NFC) technology, which is compatible with
iOS and Android platforms.
Li-Ion battery
Hilti Li-ion battery type series used. Observe the information given in the section headed In-
tended use.
1.3.2 Highlighting of designations and markings
Designations and markings are indicated as follows:
‚ ‛ Description of marked operating controls on the fastening tool
« » Markings on the fastening tool
1.4 Product information
Hilti products are designed for professional use and may be operated, serviced and maintained only by
trained, authorized personnel. This personnel must be specifically informed about the possible hazards. The
product and its ancillary equipment can present hazards if used incorrectly by untrained personnel or if used
not in accordance with the intended use.
The type designation and serial number are printed on the rating plate.
▶ Write down the serial number in the table below. You will be required to state the product details when
contacting Hilti Service or your local Hilti organization to inquire about the product.
Product information
Fastening tool, gas-
actuated
Generation:
Serial number:
1.5 Declaration of conformity
We declare, on our sole responsibility, that the product described here complies with the applicable directives
and standards. A copy of the declaration of conformity can be found at the end of this documentation.
The technical documentation is filed and stored here:
Hilti Entwicklungsgesellschaft mbH | Tool Certification | Hiltistraße 6 | 86916 Kaufering, DE
2 Safety
2.1 Safety instructions
These safety instructions apply for fastening tools with and without magazine.
General instructions concerning personal safety
▶ Stay alert, watch what you are doing and use common sense when working. Do not use the tool while
you are tired or under the influence of drugs, alcohol or medication. A moment of inattention while
operating the tool may result in serious personal injury.
▶ Wear your personal protective equipment and always wear protective glasses. Depending on the
application and type of tool in use, wearing personal protective equipment such as a dust mask, non-slip
safety footwear, hard hat and ear protection reduces the risk of injury.
▶ Always wear gloves if cleaning or maintenance has to be carried out before the tool has been allowed to
cool down.
▶ Wear suitable ear protection (see noise information in the technical data section). Fasteners are driven
through ignition of a gas/air mixture. The resulting noise exposure may cause damage to the hearing.
Other persons in the vicinity should also wear suitable hearing protection.
▶ Adopt the correct posture when working. Maintain proper footing and balance at all times. This will give
you better control of the product in unexpected situations.
16 English
GX 2
01
2126831
*2126831*