Publicidad
Idiomas disponibles
Idiomas disponibles
TOOLS REQUIRED FOR ASSEMBLY (not included)
•
Flat head screwdriver
•
Phillips head screwdriver
•
8mm wrench
•
10mm wrench
•
12mm wrench
•
13mm wrench
DO NOT lift saw without help. Hold it close to your body while
•
lifting. KEEP knees bent and lift with your legs, not your back.
•
Fully assemble saw with leg assembly prior to use. Leg
assembly is an integral and necessary part of the support
structure for this saw.
•
DO NOT modify saw, or create accessories not recommended
for use with this saw.
•
Make sure power switch is in "OFF" position before connecting
to power supply.
•
DO NOT connect to power supply until assembly is complete.
Avoid contact with blade teeth. KEEP blade
stored or lowered when possible.
STAND
Hardware Bag "A"
1.
Connect the two Tube Legs together by inserting the end
of the Left Leg
PC2
Using a 13mm Wrench, secure them together with a M8 x
75mm Carriage Bolt
Nut
and tighten. See Figure 1.
HP2
2.
Insert the four open ends of the Tube Legs into the Leg
Collars
as shown. Using a 10mm Wrench, secure each
A
Leg to the Saw Body with (4) M6 x 72mm Carriage Bolts
and (4) M6 Nylock Nuts
HP4
FIXED WHEELS AND STATIONARY
FEET
Hardware Bag "B"
1.
Using a 13mm Wrench, attach the two Fixed Wheels
to the Left Leg using the (2) M8 x 53mm Carriage Bolts
and M8 Nylock Nuts
HP6
shown in Figure 3.
2.
Screw the Adjustable Feet
the Right Leg.
3.
Carefully stand the box right side up and remove packaging
once the machine has been lifted from the ground. See
Figure 4.
The machine is heavy, two people may be
required to stand the machine up.
4.
The two Adjustable Feet
rotating them clockwise or counterclockwise. The Feet
may be adjusted to level the Saw and can be locked in
place with the pre-assembled Set Screws using the
provided 6mm Allen Wrench
ASSEMBLY
•
3/8 inch wrench
•
7/16 inch wrench
•
Framing (Carpenter's)
Square
•
Combination Square
•
Straight Edge
into the end of the Right Leg
, M8 Flat Washer
, M8 Nylock
HP1
HP3
and tighten. See Figure 2.
HP5
. One for each wheel as
HP2
into the threaded inserts in
PC12
can be raised and lowered by
PC12
. See Figure 3.
HP22
PC3
HP2
.
PC3
PC12
HP22
PC13
17
HP1
HP3
Figure
1
Figure 2
HP2
HP6
Figure 3
Figure 4
PC2
A
PC13
Publicidad
