Publicidad
Idiomas disponibles
Idiomas disponibles
5.
Loosely assemble three 5/16 18 x 7/8 inch Hex Head
Screws with Split Lock Washers
Washers
and three 5/16-18 Hex Flange Nuts
HP16
the three holes into the side of the extension wing as
shown. See Figure 12.
NOTE: The 5/16-18 Hex Flange Nuts
5052 T2.
6.
Carefully lower the slotted wing attachment
the screws on the extension wing. Tighten the screws after
the wood table is leveled with the extension wing.
7.
Using the Rail Alignment Gauge
the table legs so the top of the table is at the proper
distance from the rail.
8.
Drill 1/4 inch holes through the rail holes
wood table on the front and back rails. See Figure 13.
9.
Fasten Wood Table Extension to Front Rail using six 1/4-20
x 1-1/2 Pan Head Hex Socket Screws
1.58 Flat Washers
HP27
10.
Fasten Wood Table Extension to Rear Rail using six 1/4-20
x 1-1/2 Hex Head Screws
Washers
and 1/4-20 Hex Nuts
HP27
FENCE GUIDE AND POWER
CONTROL BOX
Hardware Bag "E" for 36-5000T2 and 36-5100T2
Hardware Bag "G" for 36-5052T2 and 36-5152 T2
1.
Attach the fence guide
36-5000 T2 and 36-5100 T2) or six (for 36-5052 T2 and
36-5152 T2) 1/4 20 x 1/2 inch Button Head Hex Screw w/
Split Lock Washer
bottom side of the front rail.
2.
Align the two holes in the switch box bracket with the holes
underneath the front rail, shown in Figure 15, located on
the left side of the saw. Secure the switch box
front rail using two 1/4 20 x 1/2 inch Hex Screw w/ Split
Lock Washer
.
HP19
ASSEMBLY
, 8 x 16 x 1t Flat
HP7
are only used on the 36-
HP14
down onto
PC22
adjust the feet
HP20
A
, 6.74 x 20.63 x
HP17
and 1/4-20 Hex Nuts
.
HP28
, 6.74 x 20.63 x 1.58 Flat
HP26
.
HP28
to the front rail using four (for
PC19
through the holes
HP18
C
into
HP14
HP7
in
B
into the
on the
to the
F3
21
PC22
Figure 12
A
HP20
B
Figure 13
FENCE GUIDE
C
Figure 14
HP30
Figure 15
Publicidad
