INSTALLING THE HANDLES
Elevation and Bevel Hand Wheels
The elevation and Bevel Handles are packaged together in the box,
please install as follows:
1.
Insert one Handle
PC14
in the front of the Saw, as seen in Figure 16.
2.
Insert one Handle
PC14
the right side of the Saw, as seen in Figure 17.
INSTALLING THE RIP FENCE
HANDLE
The Rip Fence Handle is packaged individually and labeled
accordingly, please install as follows:
1.
Screw the Labeled Handle
supplied Hex Wrench. See in Figure 17.
IMPORTANT: Before raising Blade you MUST release Bevel
Lock and tilt Blade 45° and remove styrofoam block under Motor
Housing. See Figure 18.
ASSEMBLY
to the Elevation Hand Wheel located
to the Bevel Hand Wheel located on
to the Rip Fence with the
PC15
22
PC14
Figure 16
PC15
PC14
Figure 17
(REMOVE)
(REMOVE)
Figure 18