Publicidad
Idiomas disponibles
Idiomas disponibles
Off season maintenance (Removing injectors)
If you will have the car sitting for more than 3 weeks without running, follow the instructions below:
a.
Drain or seal your fuel system
b.
Remove the injectors from the car
c.
Pulse each injector continuously for 3 seconds, applying clean/dry compressed air (30 to 90 psi) into the fuel inlet portion of the injector. This
operation removes residual fuel from inside the injectors.
d.
Store your injectors in a plastic sealable bag
If you do not use an oxygenated fuel simply seal your fuel system off by capping the breather and keep the fuel cell or tank filled to the top.
Do not attempt to disassemble the product or to remove or replace any of its components. Any attempt to do so could damage the product and will
void the product warranty. FuelTech will not service or replace any injector that has been opened or where attempts to open are visible. Failure to heed
any of the warnings or precautions described in this manual may cause engine damage and will void this product warranty.
Off season maintenance (without removing injectors)
If you will have the car sitting for more than 3 weeks without running, follow the instructions below:
a.
Remove and drain the fuel rail
b.
Turn on the ignition and go to the Outputs menu in the FTManager software, hold the "lightning bolt" test output feature button continuously for
3 seconds whilst applying clean/dry compressed air (30 to 90 psi) into the fuel inlet portion of the injector. This operation removes residual fuel
from inside the injectors.
c.
Assemble the fuel rail. This procedure is necessary if the vehicle will be sitting for more than 3 weeks without running.
This procedure is necessary of the vehicle sitting for more than 3 weeks without running.
IMPORTANT
Do not disassemble the product or remove/replace any components. Doing so may damage the product and
will void the warranty.
15
EN
Publicidad
