OHAUS VALOR 5000 Serie Manual De Instrucciones página 17

EN-11
3.4.2 Menu
Use the four buttons marked with Yes, No, Back and Exit to navigate through the menus (refer to
Section 3.2).
• Yes - Enters the displayed sub-menu or menu item and accepts the displayed setting.
• No - Skips to the next sub-menu or menu item and changes the displayed setting.
• Back - Goes back to the previous sub-menu or menu item.
• Exit - Immediately exits the Menu mode.
3.4.3 Changing Menu Settings
Enter the menu by holding down the Menu button until Menu is displayed. When the button is
released, the first available sub-menu is displayed.
• Navigate to the desired sub-menu using the No button.
• Enter the sub-menu using the Yes button.
• Navigate to the desired menu item using the No button.
• Enter the desired menu item using the Yes button.
• Change the setting using the No button or accept the setting using the Yes button.
• Continue navigation using the Yes, No and Back buttons or return to weighing using the Exit button.
3.5 Application Modes
Two application modes are available : Weigh and Checkweigh. To enable the Checkweigh mode,
Checkweigh must be turned on in the Mode menu (refer to Section 3.7.5).
3.5.1 W e i g h i n g
Determines the weight of an item in the selected unit of measure. Scale is shipped with kilograms
(kg) and pounds (lb) enabled. To enable other units of measure, they must be turned on in the
Unit menu (refer to Section 3.7.4).
3.5.2 C h e c k w e i g h i n g
Use this mode to compare the weight of an item to Under and Over target limits. When the checkweigh
mode is enabled, the "CHECK" indicator will turn on.
To set the target limits, refer to Section 3.6 Checkweigh Target Settings.
Place the sample on the weighing pan. If the sample weight is under the target weight range, the
yellow LED will light. If the sample is within the target weight range, the green LED will light. If the
sample is over the target weight range, the red LED will light. The LED indication is complemented by
an audible alert feature (refer to Section 3.7.5).
Normal Checkweighing
Set both targets as positive values, where the lightest acceptable weight is entered as the Under target
limit and the heaviest acceptable weight is entered as the Over target limit. Items placed on the pan
will be compared to the targets.
Navigation
Valor 5000 Series