Publicidad
Idiomas disponibles
Idiomas disponibles
PRODUCT INSTALLATION
CONNECTING COLD WATER SUPPLY (CONT.)
2 . Turn off Water Supply Valve and flush toilet
a . Turn Water Valve off to stop the flow of water .
b . Flush toilet and hold down handle to completely
empty tank .
c . Disconnect Water Supply Hose from toilet tank .
Do not disconnect from the Water Supply Valve .
NOTES:
• You may wish to place a container under the tank to
catch any excess water .
• Do not continue without completing the above steps .
• Failure to do so could result in flooding, leaking or
damage to the Swash .
3 . Connect T-valve to the Toilet Tank Fill Valve
a . Place the Rubber Washer into the T-valve .
b . Install the T-valve with the rubber washer to the incoming
water connection on the bottom of your toilet tank .
NOTES:
• The T-valve connects to the fill valve directly under
your toilet tank - it does not connect at the wall .
• Only connect to the toilet cold water supply line .
• If your water supply line is rigid, you may need to
replace it before continuing .
4 . Connect the water supply line coming from the wall to the
bottom of the T-valve .
6
6
Step 2c
Step 3a
toilet tank
T-valve
cold water
supply line
Steps 3-4
PRODUCT INSTALLATION
CONNECTING COLD WATER SUPPLY (CONT.)
5 . Install Mounting Plate
a . Place Adjustable Mounting Plate over mounting holes
on toilet, rubber side faces down, curved edge faces
toward the toilet tank .
b . Place the Adjustable Brackets groove side down on
the center of the square opening in the Mounting Plate,
then insert Mounting Bolts through the Adjustable
Brackets and through the bolt holes in your toilet .
Be sure that the square Mounting Bolt Head is flush
with the sides of the Adjustable Bracket .
c . Slide Barrel Nut onto Mounting Bolts under the toilet
bowl and tighten to keep mounting plate in place .
6 . Attach the Swash to the Mounting Plate
a . Set the Swash flat on the toilet bowl in front of the
Mounting Plate and slide Swash onto plate until it is
secure and "clicks" into place .
b . If the Swash appears too short or too long for the toilet,
adjust the Mounting Plate accordingly . To adjust the
Mounting Plate, loosen Barrel Nuts underneath the
toilet and slide Swash forward or backwards as needed .
Once the Swash is lined up properly, tighten Barrel Nuts
to hold in place .
NOTES:
• If you follow the mounting directions in 6b and your
seat still won't mount flush with the lip of your toilet,
depending on the width of your toilet's bolt spread,
you can insert the bolts through the top brackets
above the main brackets on your Mounting Plate to
move your seat up another ¾ inches .
7 . Connect the Bidet Hose to the Cold Water Inlet
a . Connect the Bidet Hose to the Cold Water Inlet .
Hand-tighten to secure . Take care not to twist the bidet
hose, excessively bend it, or strip the plastic screw
threads when screwing the hose onto the bidet seat .
8 . Connect the open end of the Bidet Hose to the T-valve .
9 . Turn on water supply
a . Open the main water supply valve slowly
and check for leaks .
b . Wait 5 minutes, check again, and if there are no
leaks, continue .
Steps 5b-5c
Step 6a
Step 7a
Step 8
7
7
Publicidad
