Kroeplin B440 Manual De Instrucciones página 16

2. Display and operating keys
Display:
No. Display Function
Without Continuous tracking of
the measured value and
pointer in relation to the
position of the caliper
1 REL Switching from Abso-
lute mode into Relative
mode,
the Absolute mode will
not be displayed sepa-
rately
2 MIN Finding and saving of
the minimum measured
value
Requirement:
Measuring axle is verti-
cal to the measuring
surface.
3 MAX Finding and saving of
the maximum measured
value
Requirement:
Measuring axle is verti-
cal to the measuring
surface.
Application
Absolut mode: Direct finding and reading of the measured value
Switch can be done in every mode,
but should be done in MIN, MAX or HOLD Mode, as the last measured
value can be set to 0.
For internal diameter and wide grooves.
Steadily pivot gauge vertically
Measurement:
Measured value
too high
For small grooves where a vertical panning is not possible,
Move gauge horizontally back and forth.
Measurement:
Measured value
too small
16
Measured Measured value
value correct
Measured value Measured value
correct
too high
too small