Publicidad
Idiomas disponibles
Idiomas disponibles
Important safety... / Safety system / Preparations for use / Cleaning and Care
Do not cover the control
on the heating pad when the pad is in operation.
The electronic components in the control
the heating pad cause the control
up slightly during operation.
Do not pull, twist or crease the cables.
Safety system
Note: the heating pad is equipped with a safety
system. The electronic sensor technology prevents the
entire surface of the heating pad from overheating
by automatically switching off in the event of a fault.
If the safety system switches the heating pad off auto-
matically due to a fault, then the function display
on the control unit
is no longer illuminated, even
1
if the heating pad is switched on.
Please note that, for safety reasons, the heating
pad must not be used after a fault and must be
returned to the service address indicated.
Preparations for use
Note: the heating pad may smell of plastic the
first time you use it, but this will disappear after a
short period of time.
To begin, first connect the control
heating pad with the plug-in connector
(see fig. B).
Switching on / off / Selecting
the temperature
Switching on:
Set Level 1, 2, 3, 4, 5 or 6 on the control
switch the heating pad on.
Note: The function display
heating pad is switched on.
Note: this heating pad features rapid heating,
which allows it to heat up within the first 10 minutes
of operation.
Switching off:
and do not place it
1
of
1
to heat
1
Note: the function display
Selecting the temperature:
2
Note: The heating pad switches itself off automati-
cally after about 90 minutes. The function display
then starts to flash.
to the
1
3
to
1
illuminates after the
2
Set Level 0 on the control
heating pad off.
2
Just before using the heating pad, set it to the
highest temperature setting (level 6). This will
cause the heating pad to warm up quickly.
If you wish to leave the heated pad on for several
hours, set the lowest temperature (level 1).
Temperature levels
Set the required temperature level on the
control
(see fig. A).
1
Level 0:
off
Level 1:
minimum heat
Level 2–5: customised settings
Level 6:
maximum heat
Automatic switch-off
Then select the setting "0" and after about
5 seconds, reset the heating pad to the desired
temperature setting to switch it on again.
Switch the heating pad off (setting "0") if
the heating pad is not to be used after it has
switched itself off automatically.
Cleaning and Care
FROM ELECTRIC SHOCK! Always
remove the mains plug from the socket
and the plug-in connector
3
from the heating pad (see fig. B) before cleaning
to switch the
1
ceases to illuminate.
2
RISK TO LIFE
with the control
1
GB/MT
33
Publicidad
