Publicidad
Idiomas disponibles
Idiomas disponibles
2. Install the Lavatory
Drill 1/4" mounting holes at the marked locations on the finished
wall and the floor.
NOTE: You can also use other fastening devices of sufficient size
and strength.
Install the hanger bolts to the backing material so they extend
3/4" (1.9cm) beyond the finished wall.
Install the faucet and drain to the lavatory according to the
manufacturer's instructions.
CAUTION: Risk of product damage. Do not overtighten the
wood screw. Overtightening may damage the product.
Move the pedestal over the drilled hole in the floor, and secure
the pedestal to the floor by carefully tightening the wood screw
and washer.
Carefully set the lavatory on the pedestal so the hanger bolts
extend through the lavatory anchoring holes.
CAUTION: Risk of product damage. Do not overtighten the cap
nuts. Overtightening may damage the product.
Install the cap nuts and washers to the hanger bolts. Level the
lavatory, and carefully tighten the cap nuts until snug.
Kohler Co.
5
1016182-2-B
Publicidad
