AGA Unicontrol Serie Manual De Instrucciones página 6

06 GB. Operating instruction for FLOWREG corresponding to EN 2503.
6.4 If it is suspected that the Cylinder Pres-
sure Regulator is not functioning correctly,
or is found to have any form of a leak, close
the Cylinder valve and remove from service
immediately.
Do not under any circumstances undertake,
or allow any repairs by unauthorised per-
sonnel.
7. Repairs
7.1 Repairs of Cylinder Pressure Regulators shall
be carried out by competent personnel at an
authorised Service or Repair Workshop.
Only genuine spares may be used.
7.2 Repairs or modifications carried out by the
user or a non-authorised third party will entail
loss of liability.
8. Repairs
• Paragraphs 1 to 7 of these Operating Instruc-
tions applies also to Cylinder Pressure Regu-
lators with Flow gauge. The flow set by the
Pressure adjusting knob (5) may be read at the
Flowmeter gauge (4).
• Cylinder Pressure Regulator with flow gauge
have an integrated throttle (8). If the appara-
tus or equipment to be used downstream also
has a Flowmeter device, please remove it as it
will not be calibrated with the Cylinder Pres-
sure Regulator.
Atention
Please use these AGA products exclusively for
the purpose indicated by AGA and only if the
operator is fully conversant with current prac-
tices and procedures. If any further information
or assistance is required with applications of a
product please contact your local AGA specialist.