Blooboost 545150011 Manual De Instrucciones página 51

545150011
CLEANING AND CARE
Wipe off powder coated surfaces with a soft, moist rag. For the lacquer surface, use suitable cleaners.
Do not clean the heater with cleaners that are combustible or corrosive. Remove debris from the
burner to keep it clean and safe for use.
TROUBLESHOOTING
PROBLEMS
Pilot will not light
Pilot will not stay on
Burner will not light
SERVICE AND MAINTENANCE
lf the pilot heater fails to operate correctly, contact the place of purchase or for advice and service.
DO NOT ATTEMPT REPAIRS YOURSELF.
Periodic maintenance should performed at intervals not exceeding 6 months or when obvious faults
like flame burning abnormality or burner discoloration exist. Flame abnormality or burner
discoloration is generally a sign of gas supply blockage or blocked burner ports.
To clean the burner ports, remove the reflector assembly by removing the three nuts at the top of the
reflector. The mesh screen may than be extracted by removing the four retention screws at the base
of the mesh screen and four screws at the top of the screen. Remove the two screws retaining the
burner assembly. Rotate the burner assembly slightly then remove the burner assembly upwards.
PROBABLE CAUSES
Gas valve may be OFF
Tank fuel empty
Opening blocked
Air in supply system
Loose connection
Debris around pilot
Loose connections
Thermocouple bad
Gas leak in line
Lack of fuel pressure
Pressure is low
Opening blocked
Control not on
Thermocouple bad
Pilot light assembly bent
Not in correct location
SOLUTIONS
Turn the gas valve ON
Refill LPG tank
Clean or replace opening
Purge air from lines
Check all fittings
Clean dirty area
Tighten connections
Replace thermocouple
Check connections
Tank near empty. Refill tank.
Tank near empty. Refill tank.
Remove and clean
Turn valve to ON
Replace thermocouple
Place pilot properly
Position properly and retry
EN
11