Publicidad
Idiomas disponibles
Idiomas disponibles
2. PREPARE THE INSTALLATION (
Parts sold separately:
- In-line blower assembly model ILB3, ILB6, ILB9 or ILB11.
- External blower assembly model EB6, EB9, EB12 or EB15.
- Custom hood liner model AL3036, AL3042, AL3948, AL3954, AL4554 or AL4560 (optional).
- ACR Series remote control (optional).
- Ducts, elbows, wall or roof caps. Refer to pages 3 and 4 for a complete list of venting options and model numbers.
- 10" round adapter with rough-in plate kit for PKEX22 series models (included with in-line or external blower kits).
NOTE: During installation, protect countertop and/or cooktop.
3. PREPARE CUSTOM HOOD
• When building a custom hood, always follow all applicable construction codes and standards.
• Make sure the cabinet is capable of supporting its own weight and the weight of the power pack. Failure to do
so may cause personal injury or damage to countertop or cooktop.
The custom hood must be constructed to fit the size and shape of the power pack.
Proper structural support is required to accommodate the weight of the hood.
Start with the custom hood base, because its position will determine the height of the
power pack. We recommend the base of the custom hood should be 3/4-inch thick
plywood. If an optional custom hood liner will be installed, we recommend the sides
and front of the custom hood to be 3/4-inch thick, assuming standard cabinet width .
If the optional custom hood liner will not be installed, the custom hood side and front
thickness is at the installer's discretion.
Run power cable to installation location. Stub out a 4-foot length of electrical cable
below the custom hood.
P
W
OWER PACK WIDTH
ITH INTERNAL BLOWER
30"
39"
45"
4. INSTALL CUSTOM HOOD LINER (OPTIONAL)
The liners are especially designed to protect the exterior base of the custom hood. Refer to the table below to find the right liner model number
for your power pack and custom hood width. To view specifications, including depth for each liner model, visit www.BestRangeHoods.com
or contact Technical support (phone number listed on page 13, in warranty text).
To install, see instructions packed with custom hood liner. The liner must be installed before the power pack.
NOTE: On some liner models, the front liner piece may overlap the power pack front flange. If so, remove the front liner piece, assemble
power pack, and reassemble the front liner piece.
L
P
INER MODEL
AL3036
AL3042
AL3948
PK2239/PKEX2239
AL3954
PK2239/PKEX2239
AL4554
PK2245/PKEX2245
AL4560
PK2245/PKEX2245
CONT
W
ITH IN
50
.
LB
54
.
LB
57
.
LB
C
OWER PACK MODEL
USTOM HOOD NOMINAL WIDTH
PK2230
PK2230
'
)
D
WARNING
!
-
LINE OR EXTERNAL BLOWER
-
36
.
LB
39
.
LB
36"
42"
48"
54"
54"
60"
6
HH0192A
HA0099A
P
LYWOOD BASE
: 3/4"
THICKNESS
4"
FOR LINER
INSTALLATION
24"
30"
TO
ABOVE
COOKING SURFACE
S
36"
.
TANDARD
H
COOKTOP
Publicidad
