Publicidad
Idiomas disponibles
Idiomas disponibles
Spraying Troubleshooting -
The filter must be cleaned every time you use your sprayer. When using thicker spray materials, the filter might need to
be cleaned more often.
NoTe - the LX60 threads are left-handed. Turn the filter
clockwise to remove, and counterclockwise to replace.
1. Perform Pressure Relief Procedure, page 7.
2. Unclip the trigger guard from the filter housing by pulling
outward from the filter housing. Unscrew the filter
housing.
3. Remove the filter from the spray gun housing and clean
with the appropriate cleaning solution (warm, soapy
water for latex paints, mineral spirits for oil-based
materials). For spray gun model LX60, the filter will
need to be unscrewed from the gun housing (turn
clockwise).
4. Inspect the filter for holes (see inset, right). Replace if
holes are found.
NoTe - NeVeR PoKe THe FILTeR WITH A SHARP
INSTRuMeNT!
5. Screw the tapered end of the filter into the gun housing
(turn counterclockwise to tigthen).
6. Reassemble the spray gun.
Spraying Troubleshooting -
The screen at the bottom of the suction tube may also need cleaning. Check it every time you change spray containers.
1. Remove the filter by unscrewing it from the suction tube.
Clean the filter with the appropriate cleaning solution
(warm, soapy water for latex materials, mineral spirits for
oil-based materials).
2. Thread the filter back into place.
If after completing all of the steps in Spraying
Troubleshooting you are still experiencing problems
spraying, refer to the Troubleshooting section (page 21).
Spraying Troubleshooting -
The sprayer filter must also be cleaned every time you use your sprayer.
1. Perform Pressure Relief Procedure, page 7.
2. Unscrew the filter housing from the side of the sprayer
with an adjustable wrench.
3. Unscrew the filter from the sprayer and clean by hand
using the appropriate cleaning solution.
4. Thread the filter (threaded end first) back into the
sprayer. Replace the filter housing and tighten with an
adjustable wrench.
If after completing all of the steps in Spraying Troubleshooting you are still experiencing problems spraying, refer to the
Troubleshooting section (page 21).
English
All manuals and user guides at all-guides.com
Trigger
guard
12
Cleaning the Spray Gun Filter
Filter
Filter
housing
Cleaning the Inlet Filter
Cleaning the Sprayer Filter
Threaded
end
(filter top)
Hole
Publicidad
