Titan Xi445 Manual Del Propietário página 6

Do not plug in the power cord until assembly is complete.
1. Lift the cart handle until it locks into place.
3. Thread the other end of the hose to the spray gun. Hold
the gun with one adjustable wrench, and tighten the
hose nut with the other.
The spray tip should not
be attached until after the
sprayer and spray hose have
been purged and primed.
5. Press the return tube onto the return tube fitting.
Squeeze clip over the return tube fitting to secure the
return tube.
English
All manuals and user guides at all-guides.com
Assembly
6
2. Thread one end of the high pressure spray hose to
the spray hose port. Hold the port with an adjustable
wrench, and tighten the hose with the other.
4. Remove cap from inlet valve
(a). Thread the suction tube
onto the inlet valve and
tighten firmly by hand. Be
sure that the threads are
straight so that the fitting
turns freely.
(a)
6. Verify that the seal is present inside the suction tube.
Thread the inlet filter into the end of the suction tube.