Publicidad
Idiomas disponibles
Idiomas disponibles
Cleaning the Sureflo™ Valve
Cleaning or servicing the Sureflo™ valve may be required if the unit has priming problems. Priming problems may be
prevented by properly cleaning the sprayer and following the long-term storage steps.
1. Remove the suction set. Loosen the fitting as shown (a)
and remove the Sureflo™ valve solenoid.
3. Check the O-ring on the Sureflo™ valve connecting
area as shown. Clean any paint residue and lubricate
with separating oil (P/N 0516444).
5. Replace Sureflo™ valve assembly by placing it over the
housing and replacing the clip.
The "L" guide on the Sureflo™ valve should be oriented as
shown or the power cord on the Sureflo™ valve solenoid
will not let the solenoid be reattached.
English
All manuals and user guides at all-guides.com
(a)
If priming problems persist see Troubleshooting section or
call Techincal Service.
20
2. Pull the retaining clip (b) from the sprayer as shown
and remove the Sureflo™ valve assembly (b) from the
sprayer. Visually inspect the inside and outside of the
Sureflo™ valve assembly. Clean any paint residue with
the appropriate cleaning solution.
(b)
4. Clean any paint residue found inside the Sureflo™ valve
connecting area.
6. Replace Sureflo™ valve solenoid.
Publicidad
