Publicidad
Idiomas disponibles
Idiomas disponibles
Assembly - Attaching the Light Kit
1
Attaching the light kit
CAUTION: To reduce the risk of electric shock, disconnect the
electrical supply circuit to the fan before installing the light kit.
□
Remove and save the three screws (HH) from the light kit
fitter assembly (F).
□
Connect the wires exiting the bottom of the motor assembly
(E) by connecting the molded adaptor plugs together (II) (blue
to blue, white to white).
□
Slide the light kit (F) into the switch housing and secure it
using the three screws (HH) that were removed in the first
step.
HH
E
II
F
2
Installing the glass bowl
CAUTION: Make sure the power is off before attaching or
removing the glass bowl.
WARNING: Allow the glass bowl to cool completely before
removing.
□
Remove the light bowl holder (KK) from the threaded nipple
of the light kit fitter assembly (F).
□
With the power off, install the two LED bulbs (J) by
screwing them into the light bulb sockets.
□
Position the light bowl (G) over the threaded nipple and
through the guide (VV).
□
Install light bowl holder (KK) to the threaded nipple to
secure the light bowl (G) properly.
F
12
E
J
VV
G
KK
Publicidad
