Publicidad
Idiomas disponibles
Idiomas disponibles
TURN ON THE HEATER
1. Open the cylinder valve.
Hand Whell
2. Along side of the appliance.
3. Press the appliance hand wheel and turn it to Position 1 (Low/Ignition).
4. Hold the hand wheel down for around 20 seconds.
5. Press the piezoelectric sparkers several times while still holding down the hand wheel. Do this until the pilot flame is lit.
6. Once the pilot flame is lit, continue holding down the hand wheel for 20 seconds.
7. Release the hand wheel and keep the appliance in Position 1 (Low/Pilot) for around 5 minutes.
8. To adjust the desired power, press the hand wheel slightly and turn it anticlockwise. Release the hand wheel while still turning it until
reaching the desired position (High/Medium/Low). Never use the appliance at intermediate positions.
9. The ODS system will automatically turn off the appliance if the content of oxygen go down. Before restarting the appliance, ventilate
the room and then repeat steps from point 2 to point7.
TURN OFF THE HEATER
1.
Press the hand wheel and turn it to Position 1 (Low/Pilot).
2.
Close the cylinder valve.
WA R NI N G :
Do not move or cover the appliance before it has cooled down.
WA R NI N G :
The cylinder must be replaced in a room free of open flames.
Check that the cylinder valve is closed.
1. Close the cylinder valve.
2. Remove the empty cylinder from the cylinder holder housing and disconnect it.
3. Check that the gaskets are in good condition.
4. Connect the new cylinder.
5. Carry out the test research for gas leaks.
1.
Always close the cylinder valve.
2.
In case of long periods of inactivity, remove the hose, the regulator and the cylinder.
3.
The cylinder must be stored in well ventilated places outdoors, and kept out of the reach of children. Never store the cylinder in
closed rooms such as vaults, garages or under stairs.
4.
Always check the condition of the disused cylinder valve. In case of doubt, contact a specialised technician.
5.
Store the heater inside rooms only if it does not have the gas cylinder.
WA R NI N G :
Never clean the appliance immediately after its use. Always wait until it has cooled down. Always make sure that the
cylinder valve is closed and that the appliance is set to position OFF. Never moisten the pilot light, the control panel or the underlying
parts. In case of accidental contact of these parts with water, do not use the appliance without having previously had it checked by a
specialised technician.
Dust, dirt and grease may impair the product performance and compromise safety.
During the combustion process, the heater needs a constant air flow.
Dust and dirt in general may obstruct this flow. It is therefore important to always keep the burner, the control panel and the
aeration slits clean.
For the correct operation of the appliance, it is essential to have it annually checked by specialised technician before using it.
During the period in which the heater is used, it may be necessary to frequently clean the rooms in which it is used, as there may be
excessive dust and dirt.
CLEANING THE CERAMIC PANELS AND THE ODS SYSTEM
Clean the external parts with a brush.
To clean the ODS pilot injector use compressed air so as to remove dust. Never use toothpicks or similar tools. The ODS system could
get broken or obstructed.
CLEANING THE AERATION HOLES AND THE STRUCTURE
Use a damp cloth to clean the structure. Do not use abrasive substances, solvents or inflammable products.
Remove the dust and any other dirt that might obstruct the air flow with a powerful vacuum cleaner or with compressed air.
DT Istr (65411)– Rev 10 02/2019
Piezoelectric Sparker
1.Low / Ignition
2.Low
CYLINDER REPLACEMENT
END OF USE AND LONG PERIODS OF INACTIVITY
CLEANING AND MAINTENANCE
Hand Wheel
3.Medium
4.High
10
Publicidad
