Hedson Drester ACE Manual De Operación página 10

interfere with the pneumatic components of the
unit.
Grounding the unit
Warning!
• The unit must be properly grounded to avoid
electrostatic discharge.
Ground the unit properly using the yellow-green
grounding cable. Connect the grounding cable
to a proper ground circuit according to local
regulations.
Ventilation and Capture@Source
DRESTER ACE units use Hedson's Capture@
Source high-speed extraction to capture harmful
emissions close to their source, minimizing user
exposure and solvent loss. The discreet vents
of Hedson's Capture@Source help keeping the
workspace open and easily accessible.
The unit can be ventilated in two ways. For both
options, the air flow speed at the opening of the
hood must comply with local laws and regulations.
Warning!
• The ventilation must be connected so that all
parts are grounded.
Option 1: If using the built-in ventilation nozzle,
connect the flange of the hood (1) to a ventilation
system approved for Zone 1.
Option 2: Connect the hood to an ATEX approved
electric ventilator using a metal ducting. The
10
Drester ACE Drester ACE
exhaust from the ventilator must be led outdoors.
When using a central ventilations system the built
in pneumatic extractor can be disconnected in
order to reduce compressed air consumption.
(See separate instruction in accessory bag with red
6mm plug)
11. PREPARATIONS FOR USE
For all preparations, raise the front panel and
secure it to its brackets, see Installation and
connection/Raising and lowering the front panel.
Solvent
Two solvent drums are needed, one empty and
one full of solvent. They:
• have to be of the same size.
• have to meet the requirements described
under Permitted solvent drums.
• have to be clean on the inside.
• must not contain any solids or other objects
that could be sucked into the pumps when
running.
1
Use eye protection
Use protective gloves
Use a protective mask
231721 Rev. 1 2022-12-01 231721 rev.1 2022-12-01